Flexible tubular heater for HR manifolds
Easy installation with a uniform finish, can be formed by hand, stored in a straight condition to save storage space, No special installation tools required.
Coil Type Nozzle Heaters are specially designed to prevent the failures of heaters against the leakage and contamination of plastic material at nozzle position. This heater can meet the higher temperature requirement prior to molding at nozzle position.
Plastic moulding machines.
Band Heaters were developed to meet industrial requirements for high temperature long lasting heaters. They are ideally suited to comply with today's new resins, which calls for ever-increasing process temperatures. An additional advantage of the Ceramic Band Heaters is that they transfer heat through conduction and radiation. This makes their tightness on barrels less critical; thus they are less prone to thermal expansion problems. .
Injection Moulding Machine, Blow Moulding Machine, Extrusion Line.
Micro Tubular Coil Heaters are small section heating elements that can be shaped in small space which allows high wattage in small space .Heater can be supplied in round ,square or rectangular section.These Heaters are designed to work in most difficult condition giving very good heat transfer and good reliability .
Hot Runner System, Hot Stamping, Plastic Rivetting, Manifold
Brass sleeve hot runner coil heater can be manufactured in different sizes (the sprue bush or nozzle) design & manufacturing, the sleeve is made of high quality Brass inner sleeve, on the outer side heating coil can be supplied in round, square or flat shape cross sections, these heaters provide temperature uniformity, thermal inertia, these can be integrated with the K type, J type or E type control temperature thermocouple.
Special Hot Runner System applications where precise & uniform heat is a must.
Energy Saving Insulation Jacket are manufactured out of high-temperature resistant glass cloth and filled with about 50mm thick, ceramic wool and mineral wool insulation. These are installed over the band heaters to prevent heat losses to the atmosphere. The jackets are installed on the full length of barrel except for nozzle, without any gap in between to avoid any heat loss.
Conserve & save heat loss on Barrels & Extruders machines.
